Effective length of compression member when effectively held in position and restrain against rotation at both ends

The maximum slenderness ratio for a member carrying compressive force due to dead load should not exceed :A.

It is assumed that the bending moment at any section of the plate girder is resisted by the

The angle connect the web and the flange plates

The length of sides of the largest right angled in the cross section of the fillet weld is designated as the

The centre to centre distance of rivets of adjacent rows measured in the direction of stress is

The permissible stress in axial tension on the net effective area of the steel section shall not exceed

In the limit state of collapse, the maximum strain in the concrete at the outermost compression fiber is taken as

When the ratio of long span to short span is less than two, the slab is designed as

The spacing of longitudinal bars measured along the periphery of the column shall not exceed

The basic value of span to effective depth ratio for span upto 10 m for simply supported beam

The minimum area of tension reinforcement shall not less than that given by the following

Compression in bars in a beam or slab when the compressive resistance of the concrete in taken into account, the modular ratio should be multiplied by

The permissible tensile stress of High Yield Strength Deformed bar conforming to IS1139 in N/mm²

The section in which the stresses in concrete and steel are simultaneously reach the allowable value, then the section is

The distance between the line of action of the resultant compression and the line of action of resultant tension is known as

The permissible stress of M 20 concrete in compression in N/mm² is

The initial lead and lift of earth work excavation in ordinary soil and depositing on bank is

The standard stacks for broken stone unless otherwise specified, the length of stack shall be of

In Auto Cad there are...........options to draw an arc

In Auto CAD the function of the key F8 is

According to the method storage, which one of the following is not identical with the others

Which one of the following is a chemically treated reprographic method

The process which specifies what the right and left hands of the worker was doing is known

The fastening pipe thread designated by size G 1/2 have a thread pitch of

With worn gear the possible speed reduction

Pick the odd one out:

The conic for which the eccentricity ,e =1 is

Which one of the following is not a conic

The roughness number N9 stands for a roughness value.

H7/r6 indicates a

According to IS: 919 the correct minimum size limit of the ISH8/f7 fit is:

Pick the odd one out

A straight line having unit length is placed parallel to the HP and is inclined to VP. The length of the front view of the line is

Which one of the following statements is true with respect to First Angle Projection

What is the recommended minimum length of arrow heads in dimensioning

Which one of the following is an abbreviation used in engineering drawing

Which one of the following is not an element of Dimensioning

Which of the following is represented by a thick continuous line

Which one of the following is an enlarged scale

The T-Square with the working edge length of 1500 ± 10 mm, is designated as

The Orthographic projection recommended by BIS is

The Indian Standard for presentation of gears on technical drawing is

The resistance R of a conductor is inversely proportional to

In a thin cylinder the ratio between circumferential stress to the longitudinal stress is

The correct statement among the followingisA.

The maximum value of the frictional force,which comes into play, when body just begins to slide over the other, is termed as

The law of which provides the basis of temperature measurement is

The Centigrade equivalent of 100°F is

The correct statement about gamma iron is.