Which one of the following is not an element of Dimensioning

Which of the following is represented by a thick continuous line

Which one of the following is an enlarged scale

The T-Square with the working edge length of 1500 ± 10 mm, is designated as

The Orthographic projection recommended by BIS is

The Indian Standard for presentation of gears on technical drawing is

The resistance R of a conductor is inversely proportional to

In a thin cylinder the ratio between circumferential stress to the longitudinal stress is

The correct statement among the followingisA.

The maximum value of the frictional force,which comes into play, when body just begins to slide over the other, is termed as

The law of which provides the basis of temperature measurement is

The Centigrade equivalent of 100°F is

The correct statement about gamma iron is.

The ability of a material to be drawn into thin wires without breaking is called

For 18 - 4 - 1 HSS, which one of the following is true

Polar moment of inertia of a solid shaft of diameter D is

When shear force at a point is zero, then bending moment at that point will be

The stress required to produce unit strain is termed as

The area of an equilateral triangle with sides of unit size is

The equivalent of 45° is

The maximum value of (sin θ + cos θ ) is

The result of (log 10x log1) is

Sum of three numbers is 20 If we multiply the first number by 2 and add the second to the result and subtract the third number, we get 23 By adding second number to three times the first number, we get

A body starting from rest moves with uniform acceleration 'a' .The velocity of the body 'v' after-time t is

The weight of a body on earth is defined as

The volume of a cone having unit radius and unit height is:

One meter is equivalent to

gm is the symbol of the unit of mass in...............system of units

Plastic shrinkage of concrete may be caused due to

With the rise of temperature the sensitivity of bubble tube

Which of the following not used in measuring perpendicular offsets

When Prismoidal formula is used for calculation of volumes it is necessary to have

The most important part of a structure is

The horizontal angle between north direction and survey line is known as

The softest rock is

Plywood is specified by

The product of Blast Furnace is known as

Plotting of an inaccessible point on a plane table is done by

The limit of water level of a still lake represents

One hectare is equivalent to

Volume of a hollow cylinder of inner diameter 'd', outer diameter 'D' and height 'h' is:

The velocity of a moving body is

The maximum frictional force which comes to play when a body just begins to slide on the surface of another body is known as

The centroid of a plane lamina will not be at the geometrical centre if it is a

Effect of a force on a body depends up on its

The forces which meet at one point but their lines of action do not lie in a plane are called

The additional finish provided to the nosing or tread of a stair is known as

The room of a building in which stair is located is known as

A drop man hole is provided if.

Closed contours of decreasing values towards their centre, representB.