Volume of a hollow cylinder of inner diameter 'd', outer diameter 'D' and height 'h' is:

The velocity of a moving body is

The maximum frictional force which comes to play when a body just begins to slide on the surface of another body is known as

The centroid of a plane lamina will not be at the geometrical centre if it is a

Effect of a force on a body depends up on its

The forces which meet at one point but their lines of action do not lie in a plane are called

The additional finish provided to the nosing or tread of a stair is known as

The room of a building in which stair is located is known as

A drop man hole is provided if.

Closed contours of decreasing values towards their centre, representB.

Bearing Capacity of water logged soil may be improved by

Brass is an alloy of

The following sights are taken on a turning point

The triangular portion between any two adjacent and the tangents to their crown is

If more water is added to concrete to get required workability it results into

The type of bond in which the facing is of Flemish bond and filling as well as backing are a of English bond

The horizontal course provided to strengthen a wall of irregular small stones is known

In order to reduce the size of rafters intermediate supports are introduced for rafters which are known as

A slopping or a stepped pier which works as lateral support of wall is known as

The load carrying capacity of an under reamed pile can be increased by

The occurrence and extend of different strata of soil can be obtained by conducting

The setting of limestone to redness in contact with air is known as

Kaolin is chemically classified as

The value of 'Multiplying constant in a tachometer, is usually kept as

The altitude and departure, are negative in the

The process of turning the telescope over its horizontal axis through 180°, in a vertical plane in theodolite traversing is

The process of spacing the contours proportionally, between the plotted ground points, is known as

The correction for curvature, in meters, is

Line joining the optical center of the objects glass, to the center of the eye -piece, in a telescope is termed as

The accessory of a plane table, used for centering is

The method of plane tabling, used for locating the distant and Inaccessible points, is

The horizontal angle, which the magnetic meridian makes with the true meridian, is known as

The whole circle bearing of a line is 165° Its reduced bearing is

The bearing of a line, in the direction of the progress of survey is

In commutation of area, the rule in which the total number of coordinates, must be odd is

An example for an obstacle in chaining, where chaining is free and vision obstructed,is

The longest of the chain lines, used in making a survey is

The process of establishing intermediate points, on a straight line, between the terminal points, in surveying, is termed as

The 'total strain energy' stored in a body is termed by

Permissible stress is also known as

The poison's ratio is the ratio between

The unit of Strain is

The property of a material to resist penetration or Indentation is called

The 'coefficient of friction' is the tan value of the

The maximum friction force, at the time of impending motion, is equal to

The polar moment of inertia of a square lamina, with side 'a' is equal to

The unit of moment of inertia is the fourth power of

The C.G of a solid circular cone, divides the axis in the ratio

The center of gravity of a semi-circle of radius 'R' from its base, measured along the vertical axis is

The couple of two unlike parallel forces,produces a