Forces, whose lines of action, meet at a point when produced are known as

Joule is the unit of

An example, for a 'Scalar Quantity' defined by its magnitude alone is

The effective span of purlins, in a roof truss,is

The permissible bending stress, in the slab base , of steel column is

Slenderness ratio, of a axial compression of the member, is the ratio of effective length (le) to the of the member

In a steel tension member, with yield stress fy, the permissible stress in a axial tension, is

The permissible value of deflection, in a steel beam, whose effective span length l is

As per IS 800 - -1984 the pitch of the rivets,should not be less than

An example, for the designation of a steelI-section is

The average value of yield stress, for mild steel, is

The equivalent length (effective length) of a column which is effectively held in position at both ends, but not retrained against rotation iS

The permissible stress in direct compression,in concrete, as in the case of an R.C.C.column, for M 15 grade of concrete is

The size of the square mesh of steel bars, provided at the corners of a two way slab is

A two-way slab is generally provided when the length of the rooms

Curtailment of steel bars, in a beam, is possible, since

In cantilever beams, compression is developed at the

In a RCC beam, the uniform distribution ofshear stress, with a maximum value of Tv =V/b*d is called

In the reaction, M R= Q*b*d² for the beam design, the letter Q represents, the

In an under- reinforced section, of RCC beams, the depth of actual neutral axis is

The permissible tensile stress in steel for M.S bars is

The permissible bending stress in concrete for M 20

The usual range of percentage' is included in the presence of water, during concrete setting, over a period of

Length of 'Common Rafter' in a tiled roofing,when the size of root, is 1/3 span 'is

In the analyses of rates, the provision the provision included, as contractor's profit is:

The amount to be spent for the completion of unit quantity of a particular work, is

In steep grounds, to prevent the slipping down of soil, the method is

In areas where rainfall is very heavy, the suitable type of roofing is

Which of the following, is not an example for a continuous stair

The inner surface of a arch, is termed as

The innermost central portion or core of the tree is called

The widely used type of sand is

An example, for the chemical classification of rocks, is

A prop' in a beam, is used to make the point of application

The moment required to rotate the end ofa beam, while acting on it, through a unit angle, without translation of the far end is known as

The theorem of a three moments, is also known as

The deflection at the center of a fixed beam, carrying a central point load, when compared to simply supported beam,reduced by

The slope at both ends, of a fixed beam,will be

A fixed beam is also termed as

Mohr's theorems are used, to obtain the slope and deflection of beams, by

For a simply supported beam, with symmetric loading, the slope at the center is

For a cantilever with a UDL, for the entire span, the maximum deflection, at the free end is

The shearing stresses of a beam, at the neutral axis will be

The section modulus of a circular section,with diameter, 'd' is

In a loaded beam, the moment of resistance, resist the

In an overhanding beam, the point, where the maximum bending moment occurs, is

In a simply supported beam, the point,where the maximum bending moment occurs, is

The maximum bending moment at the fixed end of a cantilever beam, with a uniformly distributed load, for the entire span is

The pressure, exerted by the retained material, on the retaining wall is known as

The limit of eccentricity, of a circular section,of diameter 'd' is