Which one of the following is represented by the area of the shear force diagram from one end up to a given location on the beam?

Choose the correct statement

Which one of the following method is not suitable for tunneling the soft ground?

Eco system is:

Which one of the following pairs is correctly matched?

In descending order of Young's modulus which one is true?

Decrease in volume of soil due to decrease in water content will not occur, when the soil is in:

Moment required to cause unit rotation at near end of a member:

A series of continuous spot weld is known as

Which joint is used to connect are........................................members of bigger sizes?

Along the principal plane subjected to maximum principal stresses

Load on connection is not eccentric for:

The point of contra flexure occurs in:

Co-efficient of consolidation is used to calculate

In a forced vortex flow, velocity v and radial distance Y related as:

For the same cross sectional area which the following beams deflect more?

The weight of hammer used in SPT test:

A groove provided on the under-side of sill, cornice etc..

Insufficient washing of sand grains in a rapid sand filter causes:

Lacings are subjected to:

Bitumen is soluble in:

Darcy's law is valid as long as Reynold's number is equal to or less than.........................

The minimum number of main steel bars provided in R.C.C.:

Which of the following methods of structural analysis is a force method?

The non-clog pump which permits solid matter to pass out with the liquid sewage, is:

According to the principle of conservation of energy, under the action of force, the sum of PE and K.E of a particle remains constant

The capacity of a strained body for doing work on the removal of the straining force is called:

------------------------apparatus is used to test liquid limit of a soil.

The partial safety factor for steel in LS of service ability is:

The ratio of young's modulus to rigidity modulus of standard structural steel is:

Non-uniform flow may caused by:

To determine the modulus of rupture, the size of test specimen used is:

Any rafter shorter than a common rafter is known as:

Fluids undergo volume change under external pressure due to:

Reduction in gradient with horizontal curve is called:

Coning plume occur under which conditions?

Select the correct statement

The penman's evapo-transpiration equation is based on:

The ratio of Static Friction to Dynamic friction is always:

Blaine's Air permeability method is used to determine:

Lateral displacement of a cantilever beam subjected to end moment is proportional to the

Time factor for a clay layer is:

A propped cantilever of span L carries a uniformly distributed load of' W' per unit run over its entire span. The value of prop reaction to keep the beam horizontal is:

A doubly Reinforced section is used for:

The distance from the centre of one rivet to the centre of the adjacent rivet in one row is called:

The size of a fillet weld is indicated

The deformation of a spring produced by a unit load is called:

Which of the following measures the particle size range?

The maximum frictional force which comes in to play when a body just begin to slide over the surface of another body is known as:

The Muller-Breslau principle in structural analysis is used for: