Blaine's Air permeability method is used to determine:

Lateral displacement of a cantilever beam subjected to end moment is proportional to the

Time factor for a clay layer is:

A propped cantilever of span L carries a uniformly distributed load of' W' per unit run over its entire span. The value of prop reaction to keep the beam horizontal is:

A doubly Reinforced section is used for:

The distance from the centre of one rivet to the centre of the adjacent rivet in one row is called:

The size of a fillet weld is indicated

The deformation of a spring produced by a unit load is called:

Which of the following measures the particle size range?

The maximum frictional force which comes in to play when a body just begin to slide over the surface of another body is known as:

The Muller-Breslau principle in structural analysis is used for:

Name the welding joint:

In a flow visualization experiment a continuous release of marked particles is produced from a point and the resulting line is:

A lead ball with certain velocity is made to strike a wall, it falls down; but a rubber ball of the same mass and with same velocity strikes the same wall, it rebounds. Select the reason from the following:

Which one of the following is the mode of failure in fillet weld material ?

A simply supported beam is considered as a deep beam if the ratio of effective span to overall depth is less than:

The beam section has to be redesigned if the shear stress exceeds the allowable shear stress by :

The product El is also known

uniformly distributed load will be:

The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is:

Dolerite is an example for:

Which one is not a part of Telescopic alidade:

An impervious wall inside an earth dam to reduce the seepage is called:

The trimmed size of Al size drawing sheet in mm is:

Total lateral earth pressure is proportional to:

The common disinfectant in rural wells is:

The cross-section of standard fillet is a triangle whose base angles are:

The angular velocity of earth is:

Weir with width of crest equal to length of channel is:

The opening in flat roof for lighting:

In consolidation testing, curve fitting method is used to determine:

Ratio of inertia force to viscous force is called

A steel beam supporting loads from the floor slab as well as from wall is termed as:

The item not included in the plinth area is:

Sewerage system is designed for:

The loss of prestress due to friction can be reduced by:

The velocity ratio of the first system of pulleys:

All revenue survey maps are plotted with reference to the ...........................meridian.

Ordinary glass is a bad conductor of:

Desire lines are plotted in:

The whole period of cultivation from the time when irrigation water is first supplied for preparation of the ground at the time of sowing to its last watering before harvesting:

Harsh mix of concrete:

For a bar of diameter d, the anchorage value of hook is:

In the plastic analysis, the ratio of plastic moment Mp to the yield moment My is called:

Lehmann's method is also known as:

The suitable camber for slow moving vehicle is:

When two cross - overs are laid between two tracks, it is known as:

The irrigation water in canal is available at such a level that it can flow over the adjoining land by gravity is

When the water table is close to the ground surface, the bearing capacity of a soil is reduced to:

------------------------------- is a type of utility based harbour