Hammering is done in rivet to....................................

The effective length of a compression member of length L held in position and restrained in direction at one end and effectively restrained in direction but not held in position at the other end, is

Which of the following systems of pre stressing is suitable for pre tensioned members

The lap length in compression is not less than

In a singly reinforced concrete beam, if the stress in concrete reaches its design strength later than the stress in steel reaches its design strength then the beam is said to be(

The effective length of a fillet weld is

If d' is the distance between the flange angles, the vertical stiffeners in plate girders are spaced not greater than

In limit state design of concrete for flexure, the area of stress block is taken as

For double angles carrying tension, placed back to back and connected to either side of the gusset plate, the sectional area of the section, is equal to cross sectional area of

The fixed support in a real beam becomes in the conjugate beam a

While using three moments equation, a fixed end of a continuous beam is replaced by an additional span of

The number of independent displacement components a teach joint of a rigid-jointed space frame is

The degree of kinematic indeterminacy of a pin-jointed space frame is

The deformation of a spring produced by a unit load is called

In moment distribution method, the sum of distribution factors of all the members meeting at any joint is always

The principle of virtual work can be applied to elastic system by considering the virtual work of

For a two-hinged arch, if one of the supports settles down vertically, then the horizontal thrust

The crest level of a canal diversion head work, depends upon

The structure constructed to allow drainage water to flow under pressure through an inverted syphon below a canal, is called

Perched aquifers are generally found

Useful soil moisture for plant growth

Lacy's regime condition is obtained if

For smooth entry of water in a canal, the angle between head regulator water is generally kept

For standing crops in undulating sandy fields, the best method of irrigation, is

The uplift pressure on the roof of an inverted syphon, is maximum when

The seating load provided in a plate load test is

Pore pressure developed in the triaxial test can be measured by .............................

The dispersing agent correction in hydrometer reading is always ....................................

The lower limit of particle size allowed in sedimentation analysis is ------------------------

Grit chambers are constructed to prevent the accumulation in........................

The bacteria that can survive without oxygen is called

The chlorine, which serves as a disinfectant is -----------------------

The warping stress is dependent on............................

Converging- diverging nozzle is also known as ............................

In fluid dynamics, the velocity of the fluid in the stagnation point is:

The distance moved by liquid will be more in which type of manometer?

The flow through a circular pipe is laminar. Now, the fluid through the pipe is replaced with a more viscous fluid and passed through the pipe again with the same velocity. What can we say about the nature of this flow?

The flow of fluid along curvilinear or curved path is known as:

The reduction in volume of saturated soil due to squeezing out of water from the soil

In an overhanging beam the point where the maximum bending moment occurs is

The process of treating a soil using suitable admixture in order to improve or alter its properties to make it strong stable and durable

Polar moment of inertia of the circular shaft section is determined by

The binary code is called

In a closed coiled helical spring subjected to axial tensile force, the nature of stress set up in the wire is

In sleep grounds, to prevent the slipping down of soil, which method is

The equivalent length of a column, with one end fixed and the other end free is

Reading of the metric levelling staff can be taken accurately up to

Which of the following is not an example for a continuous stair

The CBR pavement design curves give

The removal of excess chlorine from water is known as