When the locus of a point moving in a plane, in such away that, the ratio of its distance from the focus to the distance from the directrix is constant and greater than one is a:

In Auto CAD, Key strokes "Ctrl+Y' function defined as:

The surveying, which carried out for determining the area of unearthing relics of antiquities:

The key board function key for Online Help in Auto CAD is:

The error due to bad ranging is always:

............................................... field book is generally used for large scale surveying with detailed dimension work.

In a perfect check levelling the result of arithmetic check is always:

The most accurate method for measuring traverse angle is:

Among the following a total station does not directly measures:

The main principle of surveying is to work from:

Which among the following is determined by Hardy Cross method?

The most suitable surfacing material for bridge deck slab is

In which of the planning model was public participation was first introduced and integrated in to the system process

Two beams carrying identical loads, simply supported, are having same depth but beam A has double the width as compared that of beam B. The ratio of the strength of beam A to that of beam B is

A simply supported beam of span Im carries a point load win centre. Determine the shear force in the left half span.

The Mohr's straight theory is based on the following fact

Admixture commonly used in hot Countries

Point of inflection is known as

The point through which the resultant of the pressure acting on a surface is known as

An ascending gradient of 1 in100 meets a descending gradient of 1 in 50. The length of summit curve required to provide overtaking sight distance of 500 m will be?

Which of the following type of roller is more suitable for finishing operation of fills with sandy soil or clayey soil?

The population growth curve is:

Among which of the following conditions a T-beam becomes identical to a rectangular beam with width equal to that of flange?

The momentum correction for laminar flow is:

Three hinged arch is

The maximum horizontal distance between reinforcement in RCC slab in tension as per IS 456 is

Name the process of obtaining hand cut samples from stiff cohesive soils, which is trimmed to regular shapes and wrapped to get undisturbed samples.

Life cycle Assessment is widely recognized in association with

In doubly reinforced rectangular beam, the allowable stress in compression steel is

In a flow net

If the water for irrigation has to be lifted before it runs field is

Among the following, in which filter backwashing cannot be done for cleaning the filter?

Which of the following is inversely proportional to coefficient of permeability?

The angle measured at the change of direction of intersection of two grades in a vertical alignment known as

Loss of pre stress with time at constant strain in steel is called

In a cantilever beam carrying uniformly varying load starting from zero at the free end the bending moment diagram is a:

A soil mass is said to be in plastic equilibrium if

Precipitation caused by lifting of an air mass due to the pressure difference is

A stone that marks boundary is called

Defection can be controlled by using the appropriate

Potential flow is also known as

A block 100 mm x 100 mm base and 10 mm height. What will be the direct shear stress in the element when a tangential force of 10kN is applied to the upper edge to a displacement of 1mm relative to the lower face?

Dry density of which sample is expected to be high

Temporary hardness of water is caused by the presence of

The value of ruling gradient in plain as recommended by IRC

Which among the following is channel aligned roughly at right angles to the contours?

Coagulants are used when turbidity of water is more than:

In which of the following compass sighting and reading taking cannot be done simultaneously from one position of the observer?

On which of the following the support for flat slab is provide?

Which among the following is a flow, whose streamlines may be represented by a curve?