The walls constructed on both sides of the abutments to retain the embankment of approaches and also to protect them from the wave action of water

The slope of the outlet of 'p' trap below the horizontal is

In case of a cantilever, compressive stress is set up

If a tacheometer is fitted with analytic lens

PMGSY, a programme of the Government of India, deals with:

Total correction for elevation, temperature and gradient for a runway should not exceed :

Grade compensation on B.G tracks suggested in Indian railway is :

The general equation relating flow(Q), density (K) and space mean speed (U) is :

The diagram showing the approximate path of vehicles and pedestrians involved in accidents is :

Rate of change of centrifugal acceleration for computing length of transition curve for a vehicle with design speed V kmph is given by :

The distance travelled by a moving vehicle during total reaction time is:

In flexible pavements, wheel load is distribute by :

Flow lines and equipotential lines meet each other at an angle:

What is the range of silt size particles according to IS classification:

The method of pre-stressing concrete in which pre-stressing steel is tensioned against the hardened concrete is:

Considering the concept of durability of water tanks, the minimum grade of concrete shall be:

For preliminary calculations the thickness of the base slab of a retaining wall may be taken as .................percent of the height of wall:

Counter fort retaining wall is economical for heights above..........................m:

In design practice of beams the span to overall depth ratio are generally taken in the range:

A ................................................... section is one in which the area of tension steel is such that the ultimate limit state, the ultimate compressive strain in concrete is reached. However the tensile stain in the reinforcing steel is less than the yield strain:

The full fixity at the column may be valid only for columns supported by:

The unsupported length of transverse ties should not exceed............ times the diameter of tie in two directions:

Slenderness ratio of a member is defined as the ratio of the effective length to the........................ of a section:

Upright compression members that support decks in bridges are often called as:

One way slabs are those in which most of the load is carried on the ................................ span

Poisson's ratio of concrete is frequently taken as:

Where a member is built into a masonry wall which develops only partial restraint, the member shall be designed to resist a negative moment at the face of support is................................, Where W is total design load L is the effective span.

The percentage of chlorine in fresh bleaching powder is about:

In water treatment, rapid gravity filters are adopted to remove:

The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about:

A pipe which is installed in the house drainage to preserve the water seal of traps is called:

The gas from sludge digestion tank is mainly composed of:

Detention period of grit chambers is kept as:

The Manning's formula is given by the expression:

The planned or systematic actions necessary to provide enough confidence that a product or service will satisfy the given requirements is called

Which of the statements given below is not correct: When there is a dispute in a construction site,

If to, is the optimistic time, tp is the pessimistic time and tm is the most probable time, then the expected time of occurrence of an activity is

Decoupling of the superstructure from substructure resting on a shaking ground is called:

Which of the following does not belong to the class 'shell roof':

A bond in which both header and stretcher come in the same course is:

Deformation in concrete due to sustained loading is:

'Float' which does not interfere with the start of the subsequent activity in a project is:

As the fineness modulus of aggregate increases its particle size:

Proneness to segregation of fresh concrete is better tested by:

Steel reinforcement bars in RCC is measured in:

The covered area of a building measured at floor level is called:

Which of the following statements is not correct:

Grading of aggregates in a concrete mix is mainly essential to achieve:

Quality of reinforcing steel is evaluated by:

The two independent elastic constants for an isotropic material are: