The stress induced in a body when subjected to two equal and opposite forces which are acting tangentially across the resisting section resulting in the shearing of the body:

If drainage is permitted throughout the test, during the application of both normal, and shear stresses so that full consolidation occurs and no ex-cess pore pressure is set up at any stage of the test, is known as..........................

'S' shaped spillway is also called as:

The temperature difference between the city and its surroundings is known as:

What is the systematic departure of the declination from its mean value during a period of 24 hour?

The target mean strength of concrete is given by

A jet of water, of cross sectional area 0.005 m² strikes a flat plate normally with a velocity of 15 m/s. If the plate is moving with a velocity of 5 m/s in the direction of jet and away from the jet, what is the force exerted by the jet on the plate?

Bending moment M and torque T are applied on a solid circular shaft. If the maximum bending stress is equal to maximum shear stress developed, M is equal to:

Among which of the following conditions, Darcy's Law is not applicable to seepage of soils?

The Poison's ratio of a material having Young's modulus 200GPa and rigidity modulus 80 GPa is:

A 100 kg weight is suspended, by two strings of lengths 6cm and 8 cm, from points in the same horizontal level 10 cm apart. Tension in the shorter string is:

If the frictional stress and warping stress in cement concrete slab are 14 N/mm² and 250N/mm² respectively, then the critical combination of stress during summer mid day is ........................... N/mm²

For avoiding LS of collapse which of the following load combinations aren't considered?

The method of moment distribution in structural analysis can be treated as:

Inflow through pipe, the efficiency of transmission under conditions of maximum power transmission is:

Which one of the following method is used in the design of rigid pavements?

Among the following, in which type of canal, flow occurs only when there is a rise of flow in river.

The suitable method for distribution system for a city with hazard growth pattern is:

The mean horizontal distance between the front and rear site boundaries is termed as:

Negative skin friction on a pile under vertical compressive load acts:

Weight of 12 mm dia for steel bar in running meter?

The velocity distribution at any section of a pipe for steady laminar flow is:

The hinged end of a popped cantilever of span L settles by an amount δ, then tie rotation of the hinged end will be........................

Type of cross - drainage work where canal is passed below the drainage is:

The commonly used indicator for measuring iron concentration in water is:

What is the difference between two measured values of same quantity in surveying?

A concrete having a slump of 35 mm is termed as:

A stable submerged body has:

The elements of flexibility matrix of a structure:

The unit of mass in british system is,

Which of the following is a scalar quantity?

In engineering drawing lettering practice the width of letter W is calculated by

The formula used for finding line thickness

Which of the following conics has an eccentricity of unity?

As per BIS specification the size B2 drawing board is,

For orthographic projections, B.I.S. recommends the following:

Name the conic section curve which has zero eccentricity?

Scale used for two system of units measurement is:

When measurements are required in three consecutive units, the appropriate scale is:

The two recommended systems of placing the dimensions are:

The inclination of letters as recommended by BIS is:

In the engineering system of paper sizes, which of the following is 'A2' size?

What is the defect in surface of grinding wheel develops a smooth and shining appearance?

The size of angle plate is stated by...............................................

The which calliper is known as hermaphrodite calliper?

One micrometer is equal to .....................................

In which process wrought iron is manufactured by refining pig iron?

The size of hole is marked as 25H7What H represents?

Name the tool used in forging work for enlarging a previously punched hole?

In engineering drawing letters and numerals are designated by their .......................