The law states that in laminar flow in a saturated soil, the velocity is directly proportional to the hydraulic gradient is called:

Bleaching powder is

In a muff coupling, the outside diameter and the length of themuff are...............and................the diameter of the shaft.

Thread angle of Acme thread is:

The bearing pressure is perpendicular to the axis of shaft in ........................Bearings.

Standard size of the part, which is same for both hole and its shaft is known as:

The device used to connect two shafts together at their ends for the purpose of transmitting power is known as:

Least count of a vernier caliper is...................mm.

In order to produce air tight riveted joint.............process is required.

A machine which converts mechanical energy into pressure energy is known as:

The maximum and minimum number of steps in a flight is equal to:

................. is the short cut key of the text style.

In.................. type level, the line of collimation is not at right angles to the vertical axis if the instrument is permanent adjustment.

The uppermost or central voussiors of an arch is called:

One interior angle of dodecagon is:

The revolving line which generate the surface of the cone is called:

Granite is the example for:

Which of the following one is example for reflecting instrument?

All points on line of sights are..........................from the surface of the earth:

Fine earthenware which is white, thin and semi-transparent is called:

Conventional signs and symbols are in constant use on:

The cluster of piles which are driven around the ...................... to protect them against the floating object is:

Extensively used plate laying method in India is:

The part of the stored water in the reservoir basin which is not generally available for use is known as:

When flood occurs, the flood water just by giving proper direction, the system of irrigation so obtained is known as:

Instrument used for finding the area of irregular plane figure is:

During rainy season reservoir attains maximum water level. It is known as:

The bearing of a line in the direction of progress of survey is called:

The imaginary line joining the intersection of cross-hairs at diaphragm center of the object glass and its continuation is:

The formation of very loose mass of plastered surface due to poor bond between successive coats is:

The horizontal wooden or steel members to support the common rafters of a roof when the span is large is:

The bond in which a header course is introduced after several stretcher courses is:

The horizontal course provided to strengthen a wall of irregular small stone is known as:

The bearing capacity of a water- logged soil, may be improved by:

Soil formed by the accumulation of decaying and chemically deposited vegetable matter under conditions of excessive moisture is:

The heating of limestone to rednessin contact with air is known as:

Essential part of a centrifugal pump

In a belt drive when the arc of contact increases................increases

Screwed fastening is come under:

Thermostat valve is used in automobile engine to:

Which component is not a partof an I.C. engine?

The volumetric efficiency for a reciprocating air compressor is about:

The ratio of brake the power to indicated power is called:

The limit value stress upto which material is perfectly elastic

When a chain is used at a temperature more than the temperatures it was calibrated the error in measured length will be:

Representative Fraction (RF) is defined as:

The total internal angle of regular hexagon is................. degree.

A cylindrical magnet has....................Poles

The purpose of given heat treatment is:

Which stress is formed when the section is subjected to axial pushes?