A workpiece that cannot be held between centres because its axis has been drilled, and which is not suitable for holding in a chuck, in that case we use:

An example for sliding contact bearing:

A spark plug is used in

In heat engines:

Ring contours of higher values interval represents inside:

The box of the compass is made of:

The most common Coagulant is:

An offset more than 15 min length is called:

Multiplying constant for the tacheometer is generally:(

F9 is the short cut key:

................ states that within elastic limit stress in a material is directly proportional to strain:

The property of fluids to change the volume under an external pressure is known as

The law states that in laminar flow in a saturated soil, the velocity is directly proportional to the hydraulic gradient is called:

Bleaching powder is

In a muff coupling, the outside diameter and the length of themuff are...............and................the diameter of the shaft.

Thread angle of Acme thread is:

The bearing pressure is perpendicular to the axis of shaft in ........................Bearings.

Standard size of the part, which is same for both hole and its shaft is known as:

The device used to connect two shafts together at their ends for the purpose of transmitting power is known as:

H9 holes can be produced by...........................process

Least count of a vernier caliper is...................mm.

In order to produce air tight riveted joint.............process is required.

A machine which converts mechanical energy into pressure energy is known as:

The maximum and minimum number of steps in a flight is equal to:

................. is the short cut key of the text style.

In.................. type level, the line of collimation is not at right angles to the vertical axis if the instrument is permanent adjustment.

The uppermost or central voussiors of an arch is called:

One interior angle of dodecagon is:

The revolving line which generate the surface of the cone is called:

Granite is the example for:

Which of the following one is example for reflecting instrument?

Calculate the correction for refraction, for a distance 600 m:

All points on line of sights are..........................from the surface of the earth:

Sand passing through a screen with clear openings of 3.175 mm is known as:

Fine earthenware which is white, thin and semi-transparent is called:

Conventional signs and symbols are in constant use on:

The cluster of piles which are driven around the ...................... to protect them against the floating object is:

Extensively used plate laying method in India is:

The part of the stored water in the reservoir basin which is not generally available for use is known as:

When flood occurs, the flood water just by giving proper direction, the system of irrigation so obtained is known as:

Instrument used for finding the area of irregular plane figure is:

During rainy season reservoir attains maximum water level. It is known as:

The bearing of a line in the direction of progress of survey is called:

The imaginary line joining the intersection of cross-hairs at diaphragm center of the object glass and its continuation is:

The formation of very loose mass of plastered surface due to poor bond between successive coats is:

The horizontal wooden or steel members to support the common rafters of a roof when the span is large is:

The bond in which a header course is introduced after several stretcher courses is:

The horizontal course provided to strengthen a wall of irregular small stone is known as:

The bearing capacity of a water- logged soil, may be improved by:

Soil formed by the accumulation of decaying and chemically deposited vegetable matter under conditions of excessive moisture is: