The heating of limestone to rednessin contact with air is known as:

Essential part of a centrifugal pump

In a belt drive when the arc of contact increases................increases

Screwed fastening is come under:

Thermostat valve is used in automobile engine to:

Compression ratio of 4 stroke engine is:

In 4 stroke engines for each revolution of crank shafts the cam shaft revolves:

Which component is not a partof an I.C. engine?

The cycle consist of 2 volume and 2 isentropic process is called:

The volumetric efficiency for a reciprocating air compressor is about:

The ratio of brake the power to indicated power is called:

The limit value stress upto which material is perfectly elastic

When a chain is used at a temperature more than the temperatures it was calibrated the error in measured length will be:

Representative Fraction (RF) is defined as:

The total internal angle of regular hexagon is................. degree.

A cylindrical magnet has....................Poles

The purpose of given heat treatment is:

Which stress is formed when the section is subjected to axial pushes?

If the circumference of a circle is 44 cm, its area is equal to:

Which of the following aspects that are considered in specifying the value of FAR?

Poisson's ratio is the ratio of:

The ratio of volume of voids to the total volume of given soil is:

An aquifer is a geological formation which:

Bar chart is drawn for:

The most commonly used theodolite operations are:

The latitude and departure of a traverse line are both positive when the whole circle bearing of the tine lies in the:

Concurrent forces are those forces whose line of action:

A weir, generally used as spillwayof a dam is:

The rise in the maximum flood level of the river after construction is known as.

The most accurate method for calculating the rainfall:

A weir, generally, used as a spillway of a dam is:

The curve obtained by the movement of the recording pen of the float type rain gauge is known as:

Process by which plant dissipates water from the surface of their leaves, stalks and trunks in the process of growth is called:

The ideal shape of a transition curve is:

Modulus of rigidity is defined by:

The centre of gravity of an equal angle section will be:

Discharge over a rectangular notch is given by

The velocity of flow at which the flow changes from laminar to turbulent is known as:

In fluids, steady flow occurs when:

The liquefaction of loose sand deposits may be caused by:

In box shear test, failure plane is the:

The coefficient of permeability is proportional the void ratio (e) as

The total vertical deformation at the surface resulting from the load is called

Clayey soils are best compacted by:

Optimum moisture content is the moisture content at maximum:

The technique of finding the fair price of an existing building or property is known as:(

For D.P.C at plinth level, the commonly adopted materials is:

If point sighted is about the horizontal axis, then the vertical axis is known as

Relation between Young's modulus and cube strength of concrete is:

Type of cross-drainage work where canal is passed below the drainage is.