In cylindrical cams, the follower moves

The size of a cam depends upon

Which of the following chains fall under the category of hoisting, anchors of marine work sand hauling chains?

In roller chain, the bush and the pin form

Slip of a belt is usually expressed in

Slip of a belt is usually expressed in

The nominal inside length in tensioned state of C - 3048 -IS 2494 V belt is _______________

The power transmitted by a belt is maximum when the maximum tension in the belt (T) is equal to

Which flat belt drive system has two pulleys mounted on driven shaft and one pulley on driving shaft?

In _________Belt drive, the power transmitted from one shaft to another through number of pulleys

__________is a tightening pulley used for increasing the angle of contact/tightening of the belt

Driver and driven pulleys move in opposite directions in

Which of the following is not a exible type of connectors?

In a planning machine the depth of cut is given by

Reciprocating movement of the table in a planer is obtained by

The size of a planer is determined by the maximum length of the

What is the purpose of quick return mechanism in a slotting machine ?

Which of the following can be used as job holding device in slotting machine ?

Slotter is specified by

The feed of shaper takes place

Quick return mechanism and reciprocating movement of the ram is obtained in___________mechanism

Quick return mechanism is provided on shaper to reduce the time required for

Which one of the following parts of the shaper supports the table ?

The front of the body provides guide ways for_________

Shaper can produce contours of_______________

In which of the following milling method chip thickness decrease gradually

Straddle milling can be performed more effectively by milling machine

Which of the following milling operation can be used for machining of flat surface which is the right angle to the axis of cutter?

Which method of milling process is producing flat surface parallel to the column ?

Which of the following milling cutters have teeth on their periphery as well as on their end ?

Which of the following carries clamping bolt T-slots for fixing work piece?

Identify the lathe accessory used to give extra support for a long slender piece

Which of the following operations cannot be performed on a lathe ?

For turning internal tapers, the suitable method is

As the diameter of the workpiece decreases, the spindle speed (for the same cutting speed)

The lead screw of a lathe has ____________threads.

Lathe centres are provided with the following standard taper__________

The headstock of a lathe is situated at the

The problem of solid waste disposal can be reduced through

Which one of the following fire extinguishers is suitable for the live electrical fire ?

What A denotes in ABC of firstaid?

A transmission shaft includes

Which one of the following bushings is used to locate the renewable bushings?

Fixture is a production device which

A universal coupling is used to connect two shafts

A flange coupling is used to connect two shafts

What is the remedial measure to stop the dripping of water from house hold tap even after firmly closed?

Which type of pipe joint take branch at 90°?

Which pipe fitting is used to divert the flow direction of pipe ?

Tapered threads have a taper of