The most common admixture which is used to accelerate the initial set of concrete is:
Compressive strength of cement, after 7 days not less than.......................kg/cm^2:
To determine the compressive strength of the stone, use:
Piles driven at an inclination to resist inclined or horizontal forces:
Rapid hardening cement contains more amount of
Lime plaster is composed of:
The commonly used raw material of cement is:
Black Cotton soil is unsuitable for foundation because of:
The flooring of bridge is supported on the top of supports in:
The stress strain curve of concrete as per IS: 456 is
Column in workshop using gantry cranes, the foundation is:
For Im^3 of CC 1:1.5:3, the cement required is:
Pug mill is the device used for:
Colocrete is the commercial term for:
The scaffolding used for painting and repair works inside the room is
The rule of water cement ratio was established by:
Louvers are fixed at an angle of
The maximum differential settlement in isolated footings on clayey soil should be limited to:
The projecting course at the upper part of a pier or abutment is..............................
Which of the following bricks types use the least amount of clay?
The edge of sheets, slates or tiles projecting beyond the gable end of the sloped roof is:
--------------------------------- is a temporary dam constructed to exclude water from a specific area.
As compared to OPC, use of Pozzolona cement:
The effect of arching a beam:
The center of which arch lies on the springing line
These doors are generally constructed by thin corrugated steel sheets which all roll up on a roller or dream:
Steel is preferred as reinforcing material in concrete because :
The rubble masonry built without mortaring is:
What is a receiver in a sieve analyser?
The scaffolding used for the construction of stone work is termed as:
The main reason for providing certain minimum number of reinforcing bars at support in a SSB is to resist............................. in that zone
In pile foundation, the skin friction and end bearing are separated by:
Coping between apex and skew corbel in a gable wall is:
Flexural strength of M 25 grade concrete is:
Dead shore is also known as:
Pot tiles are also known as
In case of hand mixing of concrete, the extra cement to be added is:
Mix ratio of M20 grade cement concrete
Marble stone belongs to:
In pitched roof rafters are the members laid:
The scaffolding used for the construction of stone work is:
For well graded sand, Coefficient of uniformity is:
Forms of freshly laid rcc work should not be struck for a period called .............................. until the concrete has reached a strength at least twice the stress to which the concrete may be subjected to at the time of removal of form work.
Specific gravity of granite:
The explosives not used for blasting the rocks under water is:
The maximum strain in concrete at the outer most fibre is :
Kankar lime belongs to:
Weirs constructed on permeable foundation are Likely to fail due to:
A recess made inside the doorframe to receive the door shutter is: