The length of standard 450 setsquare is,

In aligned system of dimensioning, the dimensions may be read from,

Hatching lines are drawn at --------------------- degree to reference line:

The dotted lines represents:

The trimmed size of A4 drawing sheet is---------------------

In engineering drawing letters and numerals are designated by their ........................................

The isometric length is ----------------------percent of actual length.

The isometric projection of a circle is a,

The isometric projection of a sphere is a,

The isometric axis are inclined at --------------------- degree to each other.

The sectional plane are represented by:

A point 'P' is above Horizontal Plane (HP) and in front of Vertical Plane (VP). The point is in,

A line of 1 meter is shown by 1cm on a scale. Its Representative fraction (RF) is,

The internal angle of regular pentagon is,

Which grade of pencil used for lettering?

Which of the following represent reducing scale?

In unidirectional system of dimensioning, the dimensions may be read from,

The angle subtended by the long chord of a simple curve at its centre is equal to

Key plans are drawn

The code of practice for engineering drawing

A line of true length 398m when measured by a 20 m chain is recorded to be 400 m. What is the actual length of the chain in m?

Closed figures as a single entity of any shape that can be created with lines and arcs, can be drawn by the command:

Which of the following scales is the smallest one?

The following projection method has been recommended by the BIS for the preparation of Engineering drawing of objects:

The size of letters and numerals are designated by their:

The surface area of A1 drawing sheet is:

The ratio of the symbol of orthographic projection either first angle or third angle is:

An angle less than 90° is:

The sides of each trimmed drawing sheet are in the ratio:

In conic sections, if the section is parallel to the axis of the section then it will be

In third angle projection top view draw:

A point P is situated in 3rd quadrant, it is 2.5 cm below horizontal plane & 3 cm behind the vertical plane. Its projection on plane is:

Instrument used to reproduce plans to a different scale is called:

............................... lines are used to indicate the termination of a dimension line:

Pick the odd one out:

T square is used for drawing is:

In conic sections, if the section is parallel to the axis of the cone then it will be:

Service plan

The line connecting a view to note is called:

A 500 sq. m area is represented by 500 sq.mm in a drawing. The scale of the drawing is

A polygon having nine side is:

Geometric method of projection obtained on the plane of projection when the projectors are parallel to each other and perpendicular to the plane of projection is:

A line is parallel to VP inclined to HP then it has:

The traces of lamina is:

In the isometric projection all horizontal edges are drawn as inclined lines to horizontal line

Name of the conic whose eccentricity is one

The scale of building plan as per Kerala Building Rule is:

Trimmed size (in millimetres) of A1 drawing sheet is___________

A regular polygon with six sides is called

Special publication of B.I.S. for Engineering drawing practice for students is a