Permanent adjustment are carried out to

The line of collimation should be parallel to

Height of instrument method in leveling compared to rise and fall method is

The sensitivity of bubble tube can be increased by

Correction for curvature is

In leveling, the effect of retraction is to

Correction for error due to refraction is

Correction applied for eliminating the effect of earth's curvature is

Which of the error is personal error

Cross hair in surveying telescope are fitted

The water surface of still pond represents a

The line lying through on a level surface and normal to the Plumb line is

The benchmark established by P.W.D or government agencies is known as

A fixed point with known elevation is known as

Staff point with known elevation is known as

Alidade is used for

Trough compass is used to determine is used to determine

Accurate centering of plane table is done by

In plane table survey the method used for plotting of inaccessible points is

The method used for establishing instrument station for plane table survey is

Local attraction of compass survey is due to

A bearing is noted 45° N-E represents

Prismatic compass is used to determine

The whole circle bearing of a place is 259° then the quadrantal bearing should be

The graduations in a prismatic compass starts with a zero at ------- end

An instrument used for setting out an angle of 45 degree is

The difference between fore bearing and back bearing of a line is not 180 degree it is due to

The graduated ring of a prismatic compass is graduated in

The needle of magnetic compass is generally supported on a

If 'n' is the number of sides, the sum of interior angles of a closed traverse is

The optimum depth of kor watering is 19 cm for

The least count of prismatic compass is

The direction of a line relative to a given meridian is called

In prismatic compass zero is marked at

The main different between a map and a plan is

In a tape, the correction for temperature is C,= a(Tm-Ts)*L, where Tm stands for

An instrument which is used for survey for measuring of angles is

Miscounting of the chain length is a

Use of Planimeter is

Angle of repose

Transverse Contraction / Longitudinal Extension

The process of softening steel by heating it to a suitable temperature and the cooling slowly is known as

The property of solid where by it will sustain shock load without permanent deformation is called

Ideal R.F for site plan is

Length of curve is equal to

In a simple curve the sum of l and Φis equal to

If Contour lines touch each other at a particular zone, it indicates a:

In Chain Survey proof line is

Fluids include

This theorem proves that the energy head at any section in a flowing stream will be same