The shearing stresses of a beam, at the neutral axis will be

The section modulus of a circular section,with diameter, 'd' is

In a loaded beam, the moment of resistance, resist the

In an overhanding beam, the point, where the maximum bending moment occurs, is

In a simply supported beam, the point,where the maximum bending moment occurs, is

The maximum bending moment at the fixed end of a cantilever beam, with a uniformly distributed load, for the entire span is

The pressure, exerted by the retained material, on the retaining wall is known as

The limit of eccentricity, of a circular section,of diameter 'd' is

Due to the torque, in a shaft, every cross -section of its, subjected to

The equivalent length of a column, with one end fixed, and the other end free is

A column is a

For an isotropic, homogeneous and elastic material obeying Hooke’s law, the number of independent elastic constants is

----- riveting is considered more effective in making the joint leak proof

A bolt is specified by its

For accurate production of an object, its drawing contain

A leader line is usually

In drawing, letters and numbers are designated by their

In a title block space should be provided for

Construction lines are drawn by

Continuous thick lines are used to draw

T. Square is used for drawing

If P, V and T represent the pressure volume and temperature of a perfect gas, then the constant of proportionality universal gas constant R =

Very high temperature is measured by using

Relation between current in ampere I, emf volt V and resistance R

The ratio of lateral strain to linear strain is

The Bending Moment at the free end of a cantilever beam carrying any type of load is

Velocity ratio of system of 'n' movable pullies is

1 mile / hr = ------ m/s

Volume of an cone of base diameter D and height h is

Area of an equilateral triangle of base 10 cm is

Cos (90° - A)

Cos 30º =

If x² + 1= 10 then x =

25 % of 200 =

If (1/x) = (1/3) + (1/2) then x =

The centre of gravity of an equilateral triangle with side 'a' is ---------- from any of the three sides

Unit of power is

Unit of acceleration is

Velocity of a body is

Mass of a body is

Case hardening is done by

Pig iron is manufactured by

Bearing metal is the composition of

H.S Steel contain tungsten, chromium and vanadium in the ratio

An operation of producing an external conical surface is known as

Drilling is an operation of

In shaper the metal is removed during

The lathe centres are provided with standard taper known as

In bilateral system of tolerance the tolerance allowed is

The gib head is provided in gib head key to facilitate