A solid figure having six equal square surface is

Trimmed size of A2 drawing sheet is termed as

Ratio of the length of the drawing to the actual size of the object is termed as

Vertical member provided to divide a panel vertically is

Correction per chain length of 100 links along a slope having a rise of 1 unit in n horizontal units is

If a 30m chain diverges a perpendicular distanced from correct alignment, the error in length is

If h is the difference in heights between end points of a chain of length, r the required slope correction is

The main principle of surveying is to work from

In triangulation, the stations at which no observations are made but angles at these stations are used for continuity of the triangulation series are called

The horizontal angle between the North meridian and the line measured clock wise is known as

The surveying in which curvature of earth is taken into account is termed as

Mathematically, weight of a body is

The initial velocity of a moving particle is, u and a is its uniform acceleration. Its velocity, v after t seconds is

The vertical distance travelled by a particle upwards in t seconds is denoted by h then,

A lever which is not straight is called

Leverage is the ratio of

In the classification of simple lever, when fulcrum is in between the load and effort, it is classified as

If an object moving along a straight line covers equal distance in equal intervals of time, it is in

The ratio of the limiting friction and normal reaction is called

The angular velocity of a body making N r.p.m. is

Angular velocity of a body is expressed in

The rate of change of position of a particle is called the

Slant height of a right circular cone of radius r and height h is

Which one of the following statement is not true for isosceles triangle

Side of a square equal in area of a circle having diameter 2 cm is

When the resultant of the forces acting upon a body is zero, then the body is said to be in

Acceleration of a particle is

The distance of centre of gravity of semi-circle of radius 3 cm, lies at a distance

To find out the area of irregular figures using Simpson's Rule, divide the figure into even number of parallel strips by means of

Convex area of a circular cone having radius = 5 cm and height h = 8 cm is

Length of the side of a cube is 10 cm, the length of its diagonal is

Volume of a spherical sector whose height is 10 cm and radius 5 cm is

Diagonal of a rectangular solid is

Area of an equilateral triangle with side a is

The sides of an equilateral; triangle is a, the height of its altitude h is

A projection obtained on the plane of projection when the projectors are parallel to each other and perpendicular to the plane of projection is known as

A double ordinate passing through the focus of the conic is known as

The reverse curves connecting either two parallel lines or two non-parallel lines is known as

The part of a circle containing two radii and the arc between them is known as

The part of a circle bounded by an arc and its chord is termed as

In the King post truss there is a central vertical member Joining with the tie beam. This joint is strengthened by the

The tread width of a stair designed for a hospital building should be equal to

The width of landing of a stair case is

The rise of steps of stair, recommended for public building should be equal to

Which one of the statement is not true for a rigid pavement ?

Marked local depression in a surface under the action of traffic or weather associated with the failure of the binding agent to keep the surface consolidated is known as

The loosening of a wearing surface under the action of traffic or weather associated with the failure of the binding agent to keep the surface consolidated is known as

The by-product of distillation or evaporation of crude petroleum either by natural processes or in a refinery and is the basic constituent of asphalt, is known as

A solution of bitumen in a volatile or party volatile solvent such as kerosene or creosote is known as

The operation of excavating and shaping the surface or earthwork