The measurement of discharge in pipes can be done using a

If H is the depth of up stream water on a vertical dam and w specific weight of water, total pressure is

The concrete slump recommended for beams and slabs, is

The type of bond is which every course contains both course contains both headers and strechers is called

Which one of the statement is not correct for a concrete

Which of the following is not true?

The first staff reading after the level has been moved to a new position, is

The whole circle bearing of a line observed by a prismatic compass is 110°. It is bearing read on a surveyor's compass, is

It is more difficult to obtain good results while measuring horizontal distance by stepping

The distance between the centers of adjacent rivets in the same row is called

Along neutral axis of a simply supported beam

A reinforced concrete beam is assumed to be made of

Reactions at support of a structure can be determined if the algebraic sum of

A relatively fixed point of known elevation is called

The chain surveying is well adopted for

The property by which a body returns to its original shape after removal of force is called

When equal and opposite forces applied to a body tends to elongate it, the stress so produced is called

The most reliable method of plotting a theodolite traverse is

A traverse deflection angle is

Centering error of a theodolite produces the error

The moment diagram for a cantilever which is subjected to a uniformly distributed load will be a

The product of mass and velocity of a moving body is called

The unit of force in CGS system is

Rainfall at any place is described by

The instrument for measuring the velocity of flow is known as

If S is the sum of three angles of a spherical triangle, then the spherical excess equals

The horizontal angle between true meridian and magnetic meridian is known as

For preparation of a contour plan for a route survey

If 'h' is the difference in heights between the end points of a chain of length l, the required slope correction is

In geodetic surveys higher accuracy achieved, if

The least count of a vernier scale is equal to

The formwork from the underside of slab can be removed only after

The under surface of an arch is called

A wall constructed to resist the pressure of an earthen filling is called

The bending moment on a section is maximum where shear force

Every material obeys hooke's law within its

The velocity of a moving body is termed as a

Removal of parallax error may be achieved by

If the whole circle bearing of a line is 270°, its reduced bearing is

The zero of the graduated circle of a Prismatic compass is located at

Magnetic bearing of survey lines at any place

The vertical angle between longitudinal axis of a freely suspended magnetic needle and a horizontal line to its pivot isknown as

In setting up a plane table in any station

The operation of revolving a plane about its vertical axis so that all lines on the sheet becomes parallel to corresponding lines on the ground, is known as

The best method of interpolation of contours is by

The angle of intersection of a contour and a ridge line is

Two contour lines having the same elevation

The boundary of water of a still lake represents

The construction of an optical square is based on optical

In chain surveying a tie line is primarily provided to