Which among the following is channel aligned roughly at right angles to the contours?

Coagulants are used when turbidity of water is more than:

In which of the following compass sighting and reading taking cannot be done simultaneously from one position of the observer?

On which of the following the support for flat slab is provide?

Which among the following is a flow, whose streamlines may be represented by a curve?

The stress induced in a body when subjected to two equal and opposite forces which are acting tangentially across the resisting section resulting in the shearing of the body:

If drainage is permitted throughout the test, during the application of both normal, and shear stresses so that full consolidation occurs and no ex-cess pore pressure is set up at any stage of the test, is known as..........................

'S' shaped spillway is also called as:

The temperature difference between the city and its surroundings is known as:

The target mean strength of concrete is given by

Bending moment M and torque T are applied on a solid circular shaft. If the maximum bending stress is equal to maximum shear stress developed, M is equal to:

Among which of the following conditions, Darcy's Law is not applicable to seepage of soils?

For avoiding LS of collapse which of the following load combinations aren't considered?

The method of moment distribution in structural analysis can be treated as:

Inflow through pipe, the efficiency of transmission under conditions of maximum power transmission is:

Which one of the following method is used in the design of rigid pavements?

Among the following, in which type of canal, flow occurs only when there is a rise of flow in river.

The suitable method for distribution system for a city with hazard growth pattern is:

The mean horizontal distance between the front and rear site boundaries is termed as:

Negative skin friction on a pile under vertical compressive load acts:

The velocity distribution at any section of a pipe for steady laminar flow is:

Type of cross - drainage work where canal is passed below the drainage is:

The commonly used indicator for measuring iron concentration in water is:

What is the difference between two measured values of same quantity in surveying?

A stable submerged body has:

The elements of flexibility matrix of a structure:

The unit of mass in british system is,

Which of the following is a scalar quantity?

In engineering drawing lettering practice the width of letter W is calculated by

The formula used for finding line thickness

Which of the following conics has an eccentricity of unity?

For orthographic projections, B.I.S. recommends the following:

Name the conic section curve which has zero eccentricity?

Scale used for two system of units measurement is:

When measurements are required in three consecutive units, the appropriate scale is:

The two recommended systems of placing the dimensions are:

The inclination of letters as recommended by BIS is:

What is the defect in surface of grinding wheel develops a smooth and shining appearance?

The size of angle plate is stated by...............................................

The which calliper is known as hermaphrodite calliper?

One micrometer is equal to .....................................

In which process wrought iron is manufactured by refining pig iron?

Name the tool used in forging work for enlarging a previously punched hole?

In engineering drawing letters and numerals are designated by their .......................

Which of the following conics has an eccentricity of unity?

The ratio of width to length of an arrow head in dimensioning,

The following are the Polyhedron except,

The slenderness ratio X of the lacing bars under compression should not exceed

Thick cylinders are analysed on the basis of

The most economical section for a column is