The temperature difference between the city and its surroundings is known as:

The target mean strength of concrete is given by

Bending moment M and torque T are applied on a solid circular shaft. If the maximum bending stress is equal to maximum shear stress developed, M is equal to:

Among which of the following conditions, Darcy's Law is not applicable to seepage of soils?

For avoiding LS of collapse which of the following load combinations aren't considered?

The method of moment distribution in structural analysis can be treated as:

Inflow through pipe, the efficiency of transmission under conditions of maximum power transmission is:

Which one of the following method is used in the design of rigid pavements?

Among the following, in which type of canal, flow occurs only when there is a rise of flow in river.

The suitable method for distribution system for a city with hazard growth pattern is:

The mean horizontal distance between the front and rear site boundaries is termed as:

Negative skin friction on a pile under vertical compressive load acts:

The velocity distribution at any section of a pipe for steady laminar flow is:

Type of cross - drainage work where canal is passed below the drainage is:

The commonly used indicator for measuring iron concentration in water is:

What is the difference between two measured values of same quantity in surveying?

A stable submerged body has:

The elements of flexibility matrix of a structure:

The unit of mass in british system is,

Which of the following is a scalar quantity?

In engineering drawing lettering practice the width of letter W is calculated by

The formula used for finding line thickness

Which of the following conics has an eccentricity of unity?

For orthographic projections, B.I.S. recommends the following:

Name the conic section curve which has zero eccentricity?

Scale used for two system of units measurement is:

When measurements are required in three consecutive units, the appropriate scale is:

The two recommended systems of placing the dimensions are:

The inclination of letters as recommended by BIS is:

What is the defect in surface of grinding wheel develops a smooth and shining appearance?

The size of angle plate is stated by...............................................

The which calliper is known as hermaphrodite calliper?

One micrometer is equal to .....................................

In which process wrought iron is manufactured by refining pig iron?

Name the tool used in forging work for enlarging a previously punched hole?

In engineering drawing letters and numerals are designated by their .......................

Which of the following conics has an eccentricity of unity?

The ratio of width to length of an arrow head in dimensioning,

The following are the Polyhedron except,

The slenderness ratio X of the lacing bars under compression should not exceed

Thick cylinders are analysed on the basis of

The most economical section for a column is

Hammering is done in rivet to....................................

The effective length of a compression member of length L held in position and restrained in direction at one end and effectively restrained in direction but not held in position at the other end, is

Which of the following systems of pre stressing is suitable for pre tensioned members

The lap length in compression is not less than

In a singly reinforced concrete beam, if the stress in concrete reaches its design strength later than the stress in steel reaches its design strength then the beam is said to be(

The effective length of a fillet weld is

If d' is the distance between the flange angles, the vertical stiffeners in plate girders are spaced not greater than

In limit state design of concrete for flexure, the area of stress block is taken as