Granite is an example for

If the Froude number of flow in an open channel is more than 1 then the flow is said to be

The stream function for a two dimensional flow is given by phi =2 xy. Then the velocity at (2,2) is

Cavitation and pitting can be prevented by creating which one of the following conditions

At break point chlorination the residual chlorine

Hardness of water is due to

The best method for removal of iron from drinking water is

Dead ends in water distribution system is the limitation of

Ozone layer depletion is caused by

MPN is the unit of:

Pick out the correct statement:In Bowditch's rule of traverse adjustment it is assumed that the errors in linear measurements are

Pick out the correct statement

The object on the opposite bank of a river can be located using a plane table station on the other bank by the method of

In a traverse survey having 9 sides using a theodolite with 20 seconds least count, the permissible limit

The mean spherical surface of earth is a

The angle between magnetic meridian and geographic meridian is called :

Contour lines intersect at overhanging cliff because

260° in WCB is equivalent to:

Orientation of plane table is done

The amount, the interest from which at normal rate is equivalent to the net income from a property is called its

Initial lead for earth work excavation is

The equipment best suited for compaction of an earthen dam is

A type of contract in which payments are made not based on measurements but based on completion certificate

The amount collected along with tender form to ensure the willingness of the contractor is called

Continuation of audible sound after the original sound has stopped is called

The ratio of the total day light in the room on a given plane to that on a horizontal plane due to clear sky at an exterior point open to the whole sky vault excluding the direct sunlight called

A water supply fitting used for joining threaded pipes laid from either direction is

Which one of the construction technique give more stability to the building during earthquake

Fire load of a building is a measure of

Which of the following method is suitable for cavity wall construction

The normal gap of expansion joint building is

A slip form is best suited in the construction of

The permissible stresses for field welds are reduced to

Flexural collapse in over reinforced beam is due to

In a fillet weld the weakest section is the

Intermediate vertical stiffeners are provided in plate girders to

From limiting deflection point of view, use of high strength steel in RC beam results in

Limit state of serviceability for deflection including the effects due to creep,shrinkage and temperature after erection of partitions and application of finishes as applicable to floors and roof is restricted to

If the nominal shear stress Tv at a section does not exceed the permissible shear stress Tc

Torsion resisting capacity of a given RC section

When a portal frame with equal leg lengths are subjected to an unequal rise in temperature, then the sway of the frame is

Influence line diagram is based on

Which of the following theorems or principles can be used to find the displacement in a structure

Kani's method of analysis for indeterminate structure can be grouped under

The column analogy method can be used for analysis of rigid jointed frame for redundancy up to

The three moment theorem finds extensive use in

Shear span is defined as the zone where A. Bending moment is zero B. Shear force is zero C. Shear force is constant D.Bending moment is constant

At location of plastic hinge

A beam simply supported at both the ends of length l and carries two equal unlike couple M at two ends. If the flexural rigidity El is a constant, then the central deflection of the beam is given by

Which of the following section has minimum value of shape factor