Which one is not included in the common elements ?

Two small rubber rolls underneath the cylinder are called

Modular ratio of the two materials is the ratio of:

The property of a materiel enabling it to resist deformation under stress is called:

If the gravitational acceleration at any place is doubled the weight of a body will be:

A soil having uniformity coefficent more than 10 is called:

Permeability of Soil varies:

For high speed reduction ........................gear is used

Hardness is the resistance to:

Inversion curves are the curves of:

Image building objectives are related to .............................. type of market structure

The cross drainage work in which the HFL of natural drain is above the bed of canal is called

Levelling carried out along the given route to find the elevation of points at known distances is called:

The vertical distance a point above the datum is called:

Diagonal scale is measured to---------------------- unit

The true meridian passes through:

Which of the following one is best suitable for accurate measurement of distance?

The member which is placed horizontally to support common rafter of a sloping roof is:

Colour of mineral in powdered foam:

The outlet discharge factor is the duty at the head of:

The defect indicated by curvature formed in a transverse direction is:

Bending moment at any section in a conjugate beam gives in the actual beam:

The property of material to resist any elastic deformation is:

The most efficient channel cross section is:

Which of the following methods of structural analysis is a compatibility method?

Which admixture is used to improve workability?

Leaks in pitched roofs may be caused due to:

Shear cracks between the main wall and cross wall can be corrected using:

Steel ball is used as indentor in which of the following test:

When we provide a hinge in a structure, the members of equation of static equilibrium increases by?

Which is a flexible DPC material?

The area where agriculture is not possible without irrigation is called:

Property by virtue of which material can absorb strain energy without plastic deformation is called:

Resistance of material against any external forces is called:

The plastered area of a square pillar of side 40 cm and hieght 3 m is...................m²

The degree of accuracy of chaining over a rough hilly ground:

Distance between two neighbouring brass rings is:

The major resisting force in gravity dam is:

Which of the following is cohesive soil?

Ratio of moment of included at a joint to the moment applied at other joint is:

Alembert's principle is used for

Zeolite process is used to remove:

When a body is subjected to transverse vibration the stress induced in the body will be:

A single degree of freedom system with a spring of stiffness 100units and mass 25 units. Find the first natural frequency of the system in Hz:

The two forces of 9 N and 12 N which are acting at right angles to each other will have a resultant of:

If gl and g2 are the gravitational acceleration on two mountains A and B respectively, then the weight of body when transported from A to B will be multiplied by:

Moment of inertia of a rectangular section 3 cm wide and 4cm deep about an axis passing through its centre of gravity and parallel to width is:

In case of SHM, the period of oscillation (T) is given by:

If a spring mass- dashpot system is disturbed when its damping is less than critical damping, then the system will:

In limit state approach, spacing of main reinforcement controls primarily: