The Indian Road con (IRC) was formed in

In highway practice the degree of curve is the central angle of the curve that is subtended by:

The extreme support of a hand railing provide at the top and bottom of a light

The width of the land on the ground which is permanently taken over by the concerned highway organization

The outer edge of the roads at curves is raised with respect to the inner edges,which is known as

The slope of the line joining the crown and the edge of the road surface is called

The longitudinal joints are provided when the width of road is

The highest point on road surface is called

The full width of road acquired before finalizing a high way is

For the construction of highway

The cross sectional slope of a road for drainage of rain water is called

The Indian Roads Congress was established in

The rate of rise or fall of a road along the longitudinal directions is called

The essential gradient which has to be provided for the purpose of road drainage is called

The complete road of railway is called

Top of the grounds on which the foundation of the road rests is called

The alignment of highways are generally taken along

The recommended camber for water bound macadam road is

The width of formation of national highway in plan terrain is

The longitudinal slope of a road is termed as

The boundaries between the pavement and foot path is

The transverse slope provided on the surface of the road to remove the rain water

In level - crossing the road surface should be

The portion of road between the edge of road formation and the edge of pavementis known as

When several forces act on a body, lies in the same plane is called earth roads, and for dust control, is known as

Separate classes of highways with superior facilities and design standards, normally permit only fast moving vehicles

The test generally used for the design for road pavements

The portion of a road used by vehicular traffic is called

The type of bridges utilize wire ropes which support the road way by suspenders is named as

The inward tilt or inclination given to the road cross section of horizontal curves is called

The type of vibrator generally used for concrete road construction is

Road constructed around the city or town to avoid congested areas is called

Width of carriage in National Highway is

As per IRC the maximum super elevation for plain road is

Which one is the structure, recommended to prevent the cut hill from sliding, when hill roads are in cutting

Which one is a fault/failure that occurs in a treated road surface

The major structural component of a road composed of stone aggregate is

The cutback bitumens with a high percentage of diesel or heavy type oil, used for water proofing earth roads, and for dust control, is known as

The maximum grade a road roller can climb is

The boundaries between the pavement and shoulders or foot paths are known as

The strip of land acquired and reserved for construction and future development of a road symmetrically about the central alignment is called

The slope of the road pavement in the longitudinal direction is called

The type of curves generally provided on highways is

For the execution of highway projects

Widening of roads on curves in hilly regions is done

Raising of outer edges of road with respect to linear edges is known as

The pavement width of road depends on

Driving vehicles on wet surfaced roads is dangerous because it may

The first stage of deciding the alignment of hill road is

The rate of rise or fall of a road along its alignments is termed as