A reinforced concrete slab is 75mm thick. The maximum size of reinforcement bar that can be used is:

The sewage consists of water:

The maximum strain energy stored in a material up to the elastic limit is called:

For taxiway the permissible transverse grade:

An inverted reading is taken when the point is:

The frequency of oscillation on moon as compared to that on earth will be:

The phenomenon of rising water in the tube of smaller diameter is called:

The throat in a fillet weld is:

The minimum gradient provided on station yards for easy drainage is known as:

The item of steel which is measured in sq. m is:

Turning the telescope in a horizontal plane is called:

A recess made inside the doorframe to receive the door shutter is:

Weirs constructed on permeable foundation are Likely to fail due to:

Ringlemann's scale is used to:

Normally cargo handling is done by:

Out lines or principal lines are drawn as:

The value of the property without being dismantled at the end of the useful period is known as:

Gauge pressure is 15 m of water and atmospheric pressure is 10.33m of water. The absolute pressure is:

The curve composed of two arcs of different radii having their centers on the opposite side of the curve is known as:

The minimum number of torsional longitudinal reinforcement in RCC beams is:

The first train in India was run in between:

Multi-under reamed piles are generally provided in:

Poison's ratio rubber material:

Sewerage system is generally designed for:

A 'dock' parallel to the shore is called:

The horizontal distance between any two adjacent contours is termed as:

Polar modulus of a section is a measure of the strength of the section in:

Intermediate vertical stiffeners are provided in plate girders to:

The landing and take off the aircraft is made against the direction of wind. In no case the centreline of the runway should make an angle with the wind direction exceeding:

A gradient steeper than ruling gradient where it is not possible due to topography is.........................................

A standard measure of ductility of a material is:

In PERT technique, completion of an activity is called:

A plumbing fork is used to.........................................the plane table

Duty of a canal water is expressed in:

If the bearing of two lines AB and CB are S45° E and N 45° W, the