The most accurate method and is well adopted to soundings in harbours and across rivers of less than about 400m width is

The minimum depth of ballast for broad gauge tracks on Indian Railways is:

The command used to create a composite solid by combining several solids is :

അടുത്ത സംഖ്യ ഏത് ? 12, 23, 34,

The rainfall hyetograph shows the variation of which one of the following?

The second coat of plastering is:

The bearing of the runway at threshold is 290°, the runway number is:

According to PIEV theory, the total reaction time of driver is taken as

Co-efficient of consolidation is used to calculate

കൂട്ടത്തിൽ പെടാത്തത് ഏത് ? 5, 13, 15, 17

Louvers are fixed at an angle of

1 / 2 : 3 / 4 = 1 : x . Find the value of x ?

ഒരു സംഖ്യയുടെയും അതിന്റെ വ്യുൽക്രമത്തിന്റെയും വ്യത്യാസം9.9 ആയാൽ സംഖ്യ ഏത് ?

The flow duration curve is a plot of:

The point of contra flexure occurs in:

The rule of water cement ratio was established by:

√0.16 എത്ര?

The graduations of vertical circle of a theodolite is:

The scaffolding used for painting and repair works inside the room is

The interrelationship between the functional elements of a programme is achieve through:

Colocrete is the commercial term for:

The defect formed in a timber piece due to receiving shocks on its early(

The process of inviting bids and accepting them is known as:

The unevenness index of a pavement surface should be:

Correction for pull is:

Pug mill is the device used for:

The ratio of the lengths of consecutive radius vectors enclosing equal angles is always constant in which it is:

If the uniformity coefficient Cu = 16 and the coefficient of curvature Cc = 1 for a soil, then D30/D10, for soil is:

Load on connection is not eccentric for:

The maximum permissible chlorine contents for public supplies should be between:

Along the principal plane subjected to maximum principal stresses

WAN stands for:

Which joint is used to connect are........................................members of bigger sizes?

2 plates 16 mm and 14 mm are joined by fillet, the maximum size of fillet weld maybe:

The two parts of the T-square

The carry over factor in a prismatic member whose far end is fixed is

Steel can be easily obtained in:

The drawing essentially to be entered with the preliminary estimate:

A series of continuous spot weld is known as

Moment required to cause unit rotation at near end of a member:

Decrease in volume of soil due to decrease in water content will not occur, when the soil is in:

For Im^3 of CC 1:1.5:3, the cement required is:

Off tracking distance is also called:

Column in workshop using gantry cranes, the foundation is:

In descending order of Young's modulus which one is true?

Which one of the following pairs is correctly matched?

The colour of water is measured on:

The sleepers resting directly on girder are fastened to the top flange of girder by:

The circle of contact of earth and the cone of visual rays passing through the point of observation is called:

Eco system is: