The shape of bending moment diagram of a simply supported beam carrying point load at the centre is

The point of inflexion occur in the

In the case of circular section of diameter d, the section modulus is given by

The maximum bending stress of a beam will be at the

A square section with side b of a beam is subjected a shear force of F, the magnitude of shear stress at the top edge the square is

A cantilever length L is carrying a uniformly distributed load of w per unit run for a distance a from fixed end. The slope at free end is given by

A simply supported beam of length L carrying point load W at the mid point. What is the deflection at the centre of beam

A fixed beam of length L carrying a point loud W at the centre. The fixing moment at the end is

A propped cantilever of length 4 m carrying a udl of 2 KN/m for the entire length and propped at the end. The prop reaction will be

The support moments of the continuous beam can be determined by applying of:

The ratio of moment produced at a joint to the moment applied at the other end;without displacing it is called

In the case of fixed beam, the maximum bending moment can be reduced by

In the case of fixed beam carrying eccentric Load, the shape of BM diagram due to fixing moment will be

A continues beam 12 m long supported Over two span 6 m each carries a concentrated 40 KN each at the centre of each span. The bending moment at the support is.

The rock formed by the deposition of product of wreathing on the pre existing rocks

The process of grinding clay with water and making it plastic is known as

The lime which are obtained by the calcinations of comparatively pure lime stone is known as

The instrument used to determine the consistency of cement

The cracks which partly or completely separate the fibers of wood

A solid substance in a fine state of division and forms the bulk of paint:

The size of concrete cube used to determine the compressive strength of concreteB.

A groove provided on the underside of sill,cornice and coping so that the rain water can be discharged:

A brick lald with its length parallel to the face or direction of wall

In which bond the face elevation is of English bond and the filling as well as backing are on Flemish bond

The wedge shaped units forming the courses of an arch

The vertical member which is employed to sub divides a window or door vertically

The wooden pieces which are placed horizontally on principal rafters to carry common rafters are

The horizontal platform between two flights of a stair is known as

A board concrete pile having one or more bulbs in its lower portion is called

The method in which the approximate cost of a project is arrived based on its service unit method

The height of an embankment of formation width 10 m with side slope 1: 2 is found to be 2 m. The area of section will be

An accurate method of estimate, consists of working out the quantities of each item of works of a project

The term implies carefully taking up or down to ground and removing all materials without damage

Unit of earth work excavation

In taking the measurement of plastered area no deduction shall be made for opening exceeding

The standard unit for flooring

The quantity of mortar required for standard unit of brick work in CM 1:6

The weight per meter runs of 12 mm dia bar

A slab of 5.05 m * 3.05 m and thickness 100 mm is provided with a main bar of 10 mm dia @ 200 mm c/c and distributing bar 8 mm dia at 200 mm c/c with a cover of 25 mm.The number of main reinforcement is

Plan and Elevation of a line segment are seen coincide, the line is situated in the

Collimation line is

Reciprocal levelling is used to determine

Chromatic aberration is a defect of lens due to

1 Minute =

The maximum permissible limit of error in chain survey is

In prismatic compass, the graduations are marked from zero at the

Dip of magnetic needle at the equator is

The schedule of rates are revised and published by

Average rainfall in Kerala is

Critical velocity in a channel is