The part of the building usually located below ground level is

A spread footing which supports two or more column is termed as

The strongest and most commonly used bond in brick work

For site exploration hand augers are used up to a maximum depth of

A portion of brick obtained by cutting a brick length wise into two portion

The finished vertical side of an opening for the door, windows or fireplace is called

Horizontal member used to support the super imposed load above an opening

The masonry consists of accurately dressed stone with extremely fine bed and end joints

An unbroken series of steps between landings is called

The simplest type of sloping roof in which rafters slope to one side only can be called as

The joints which are used extend the width of boards or planks are called

The end support of an arch is

The joint formed by fitting the entire thickness of the end of one member for as short distance into another piece

Window project outside the external wall of the room

The tool used for making threads on pipes

The method of survey in which the curvature of the earth is taken into account

The instrument fixed with a vehicle to know their speed and distance traveled by them

The bearing of line taken from the starting point of the line towards the other end is called

The variation of magnetic north from the true geographical north is the

The imaginary line joining the point of same elevation in the ground

An instrument to measure area of irregular boundaries

The inward tilt or inclination given to the road cross section of horizontal curves is called

The value of broad gauge adopted by Indian railway

The type of bridges utilize wire ropes which support the road way by suspenders is named as

The type of irrigation in which water is available for irrigation throughout the year

The cross-drainage work in which the bed level of the canal is at higher level than the HFL of natural water course is called

The devices which are used to prevent the escape of foul gases inside or outside the houses are called

As per building bye laws a site plan shall be prepared on a scale not smaller than

The equipment which is used for determining the standard consistency of cement is

The heat of hydration of low heat Portland cement after 7 days should not be more than

The best and reliable method to protect building against termites is

The ability of a material to with stand abrasive action is called

The load per unit area termed as

The rocks formed by solidification of molten rock materials

The outer annual rings of a tree which transmits the sap from the roots to branches

The defect of timber which are the indication of the branches that are existed in a living tree

One yard is equal to

Piles driven at an inclination to resist inclined or horizontal forces

The oil which is the most widely used vehicle for all ordinary paints

A full brick which is laid with its length perpendicular to the face of the wall

A triangular shaped portion of masonry at the end of sloped roof

The horizontal upper part of a step on which foot is placed while ascending or descending a stairway

The under surface of an arch is termed as

The ridge formed by the intersection of two sloped surfaces having an exterior angle greater than 180°

The representative fraction 1/50000 signifies a scale

An obstacle which obstructs both chaining and ranging and ranging may be

In the whole circle bearing system S 16° 30'W will be expressed as

At a point on the equator the angle of dip is

By using a surveyors compass we determine

A curved surface, which at each point is perpendicular to the directions of gravity at that points