In levelling, the correction for curvature in metres is equal to

The contour interval depends upon the

The horizontal distance between any two consecutive contours is called

The tacheometric method of contouring is particularly Suitable

In indirect method of contouring, the best method of interpolation of contours is

The plotting of small areas which can be commanded from a single station, is usually done on the plane table by the method of

In curves the length of long chord is equal to

When the curve is to be set out over a rough ground, the method used is

Two theodolite method of setting out a curve involves

A curve of varying radius is known as

Branch of surveying in which the horizontal and vertical distances of points are obtained by instrumental observation, known as

The principle of tacheometry is used

The multiplying constant for the tachometer is

Additive constant for the tachometer is generally kept as

Imaginary line passing through points having equal magnetic declination is termed as

Magnetic bearing of a line is also termed as

The most reliable method of plotting of a theodolite traverse is

The stadia tachometry was discovered by James Watt in the year

If θ₁ and θ₂ are the angles of elevation from A to the top and bottom of a vertically held rod of length S at B, the horizontal distance AB is

Designation of a curve is made by

A is the angle of deflection of a simple curve of radius R. Then length of its long chord, is

The area of any irregular figure of plotted map is measured with

ABCD is a rectangular plot of land. If the bearing of the side AB is 75°, the bearing of DC is

The reduced level of a floor is 100.00 the staff reading on the floor is 1.500 From the same station the inverted staff reading taken on the bottom of roof slab is 1.800 The bottom level of roof slab is

The brick laid with its length parallel to the face of wall is known as

9cm x 9cm side of the brick as seen in the wall face is generally known as

The vertical sides of door and window openings provided in a wall are known as

Exposed portions of a vertical surface at right angles to window frame, are known as

The type of bond in which every course contains both headers and stretchers, is called

To construct a 10cm thick partition wall, you will prefer

The header bond is generally used for

A covering concrete placed on the exposed top of an exterior wall is known as

The type of masonry in which stones of same height are laid in layers, is called

Stone masonry of finely dressed stones laid in cement mortar or lime mortar, is

A wall constructed to protect natural slope of earth, is known as

For one cubic meter, 1: 2: 4 concrete using 20 mm metal, the quantity of coarse aggregate required is

The whole circle bearing of a line is 230°, its Quadrantal bearing is :A. -

If the fore bearing and back bearing of a line do not differ by 180°, then either one or both the ends of line, are affected by :A.

Which one of the following is not a working operation of a plane table

Finding the location of the station occupied by the table on the paper, by means of sighting to two well defined points whose locations have previously been plotted on the paper, is known as

A leveling instrument, consisting a telescope attached with level tube which can be tilted within a few degrees in a vertical plane by a tilting screw is known as

The permissible closing error in levelling survey is

Making the axis of the bubble tube perpendicular to vertical axis of the level is

The shortest horizontal distance between two consecutive contours, is called

The imaginary line lying throughout on the surface of the earth and preserving a constant inclination to the horizontal, is known as:

In a land measuring metric chain the ends of link is connected by

The sketch drawn by the surveyor during reconnaissance showing the positions of stations survey lines and their directions and the important features is known as

The use of an optical square is

When it is not possible to set up the level midway between two points. The method of leveling to carry forward the levels on the other side of the obstruction is called :

One of the methods to set out a perpendicular to the chain line is 3-4-5 method, another method identical to 3-4-5 method is